On many boats, decks are cored with end-grain balsa or plywood with a fiberglass laminate on each side. It’s not unusual for moisture to find its way into this wooden core. Stanchion bases and chainplates often leak as a boat ages, and often holes are drilled in the deck for new ...read more
We were spending hurricane season in Trinidad on our Creekmore 34 Eurisko and thought we might as well haul her out to apply another coat of bottom paint. What we found when she emerged from the water on the lift at Peak’s Marina, however, turned a three-day quick haul into a ...read more
In this video, West System Epoxies’ tech advisor and veteran boatbuilder Greg Bull explains the different tools and techniques that can be used to replace a wet core—in this case in the starboard sidedeck of the tech center’s J/22 project boat.
West System marine-grade epoxy provides an effective means of installing cleats, blocks, tracks or any other kind of hardware into a deck without compromising its watertight integrity. In this video, tech advisor and veteran boatbuilder Greg Bull goes through the steps of installing a new cleat in the foredeck of the tech center’s J/22 project boat.
In this video, West System Epoxies’ tech advisor and veteran sailor Bruce Niederer Gutzmer uses a number of different tools and techniques to install a new fiberglass-reinforced bulkhead in the tech center’s J/22 project boat. For additional information or to contact the tech center directly.
In this video, West System Epoxies’ tech advisor Don Gutzmer takes a look at some of the tools and techniques that have been developed over the years to not only make it that much easier to use marine-grade epoxy, but minimize waste and help ensure each project is a success.
In this video, West System Epoxies’ Ben Gougeon takes a look at some of the basic properties of marine-grade epoxy, as well as what it’s capable of and the different kinds of materials it can be used with: whether it’s in the context of a minor repair or an entire boatbuilding project.
"Starting my engine often wipes out some waypoints in my charting program. My multimeter tells me that the voltage to the charting system drops only .5 volt when the starter is cranking, but that seems to be enough to cause the problem. Everything else still works fine with the ...read more
