Skip to main content

Green machines

Michel Bouffard, of Sept-Iles, Quebec, Canada, asks:"I’m installing a 75-Watt solar panel and an AirBreeze 200 wind generator on my Hunter Legend 35.5. I have two 12-volt deep-cycle batteries, one starting battery, one combiner and a Perko (Off-1-Both-2) battery switch. I’m planning to use the solar panel and wind generator when I am sailing, but I also want my starting

Michel Bouffard, of Sept-Iles, Quebec, Canada, asks:

"I’m installing a 75-Watt solar panel and an AirBreeze 200 wind generator on my Hunter Legend 35.5. I have two 12-volt deep-cycle batteries, one starting battery, one combiner and a Perko (Off-1-Both-2) battery switch. I’m planning to use the solar panel and wind generator when I am sailing, but I also want my starting battery to be full. How should I hook up these two pieces of gear?"

Nigel Calder replies:

I would run the solar panel and wind generator directly to the house batteries—include appropriate fuses—and run the combiner (or an equivalent paralleling relay) between the two house batteries and the starting battery. When you are on the boat, leave the battery selector switch in the “1” (house battery) position and use this bank to start the engine: keep the cranking battery (“2” switch position) for an emergency start. I’m almost positive that your alternator is wired to the starter solenoid, and then to the load terminal on the battery switch. If so, when the switch is in the “1” position, the alternator output will go to the house batteries whenever the engine is running. The batteries’ voltage will rise, the paralleling relay will close, and the power will go to top off the dedicated start battery.

When the engine is off there’ll be no load on the cranking battery, and the solar panel and wind generator will help keep up the house batteries even when you are not aboard and when the battery isolation switch is turned off. To avoid overcharging the batteries, be sure to install a voltage regulator on the solar panel; the AirBreeze wind generator has one built in. And be sure to size the wind generator cables so there is no more than a 3 percent voltage drop. Because the voltage regulator is inside the wind generator, the reading comes from that point and not at the batteries. Undersized cables could produce more than the minimal voltage drop and that would cause the circuit to shut down prematurely.

Related

00-LEAD-210918_11HR_AZIMUT48HRS_AMO_00411

11th Hour Racing Team's Green Mission

“I’ll admit, it’s still hard to watch the boat leave the dock sometimes,” says former Volvo Ocean Race sailor Mark Towill. Since meeting during a Transpac campaign over 15 years ago, he and his teammate Charlie Enright have sailed thousands of miles together aboard two Volvo ...read more

D61_JKELAGOPIAN-3

Boat Review: Dufour 61

Dufour, long one of France’s most well-respected builders, has been producing sailboats in La Rochelle since the dawn of fiberglass boatbuilding. Having recently merged with another La Rochelle-based builder, Fountaine Pajot, Dufour has now joined other European mass-production ...read more

m138123_14_00_210609_TORE02_SE_2152_2504-2048x

The Ocean Race to be “Climate Positive”

The 2023 Ocean Race intends to be one of the world’s first climate positive sporting events, offsetting more greenhouse gasses than are produced. The two-fold effort means cutting emissions by 75 percent and investing in ocean projects that sequester carbon and restore ocean ...read more

01-LEAD-Ancients-3-2048x

Cruising Lake Superior

Almost anywhere a sailor drops the hook someone else has been there before. We are hardly ever the first. That remote Maine harbor without a soul in sight: there’s a lobster trap. The south coast of Newfoundland: the crumbling remains of a fisherman’s cabin lie hidden among the ...read more

01-LEAD-Tablet-Holder-4

Fabricating a Tablet Holder

During the pandemic, I was stuck aboard Guiding Light, a Lagoon 410, in St. Lucia for over a month. During that time, as I worked on the boat, I started by doing a spring cleaning in my spares locker and finding some parts and material that I forgot I had. As soon as I saw them, ...read more

00-LEAD-AdobeStock_486335954

A Catamaran for a New Era

Anacortes, Washington, is an unassuming sea-salty town near the San Juan Islands of Puget Sound, and the Betts Boats yard is easy for a passerby to miss. But within Betts’ facilities, the dawn of an era in Pacific Northwest production boatbuilding could be breaking with the ...read more

X5_plus_slide-01

Boat Review: Xquisite X5 Plus

The Xquisite X5 Plus is a major update of the boat that SAIL awarded Best Large Multihull and Best Systems titles in 2017. The changes were not just cosmetic, but genuine improvements to an already fine boat, making it lighter, faster and less dependent on fuel. The builder’s ...read more

01-LEAD-AdobeStock_40632434

Cruising: Offshore Prep Talk

When I began preparing Minx, my 1987 Pearson 39-2, for extended Caribbean cruising, I had to balance my champagne wish list against my beer budget. Every buck spent on the boat before leaving would be one less frosty can of Carib down in the islands. On the other hand, I had to ...read more