Skip to main content

South Pacific Storm Prep

The Open 66 racer NV strapped down in the event a cyclone should ever swing by

The Open 66 racer NV strapped down in the event a cyclone should ever swing by

Having set ourselves the task of transforming our recently purchased Open 66 ex-Vendée Globe racer, NV, into a performance family cruiser, my partner, Timo, and I found ourselves (extremely) high and dry as cyclone season approached.

The favorite cyclone strategy in Fiji is to sit your boat in a cyclone pit in Vuda Marina. This is a hole dug in the ground in which the keel and rudder fits, with the hull sitting on tires at ground level. Unfortunately for us, digging a pit deep enough for our 14-foot keel was impossible, as the bottom of the pit would end up below sea level, which in turn would cause it to collapse. Our draft also prevents us from being able to tie up among the mangroves in one of the nearby rivers—another popular option.

After months of sleepless nights, though, I now sit writing this account of the solution to the problem that we came up with from within a 20ft shipping container, on top of which our boat now lies tied down.

The container proved to be the key to our strategy to stay safe this cyclone season, since having previously taken the rudder out of the boat to replace part of the bearing, we were able to put NV’s stern directly over it. Positioning the boat at a right angle to the container allowed us to provide the boat with that much more stability, thereby decreasing the chance of movement in any kind of heavy weather.

A closeup of the support pillar inside the container

A closeup of the support pillar inside the container

To sit the boat on top of the container, we built a cradle, which we placed under one of the main bulkheads at the stern. Careful consideration went into the positioning of the cradle, so as not to bend the container’s roof. You might think with a displacement of less than 22,000lb we had nothing to worry about since containers as heavy as 30 tons are often stacked on top of one another. However, containers are designed so that the bulk of the load is transmitted through their corner posts only, as these are the only parts where the stacked containers come in contact with one another. In our case, we were planning for the cradle to span the entire length of the container, which meant we also needed to be sure it wouldn’t cause the container’s relatively flimsy corrugated steel roof to collapse.

To ensure this wouldn’t happen, we ran a plank along one of the long edges of our container from one corner post to another, so that it would serve as a kind of foundation for the cradle. We also laid strips of wood in the troughs of the corrugated sheet metal to level out the peaks and valleys, so to speak. This way, if and when the plank supporting the cradle ever flexes, the force will be evenly spread out across the entire surface. Finally, we also reinforced the container from within by placing a sturdy metal pillar in the middle of the wall supporting the cradle.

Meanwhile, up at NV’s bow we built yet another cradle, which we sat on top of a strong metal framework positioned under yet another one of NV’s bulkheads.

For Timo, Joanna and their infant son, Nemo, home is where the container is

For Timo, Joanna and their infant son, Nemo, home is where the container is

With NV now secure on her two cradles, we set the about business of filling the container with our heaviest gear, including sails, anchors, anchor rode, etc. We also buried a set of concrete blocks to either side of NV, each of which has a chain partially welded inside to which we were able to attach a number of cyclone straps to hold both NV and the container down in the event of severe weather.

In the end, we are both very happy with this setup, which we feel to be very strong. In addition to helping us secure NV, the container also serves as a kind of workshop and storage area during this wet and windy time of year, making it a huge help with our ongoing refit. We also plan to use it to ship some of our sails, the two cradles we’ve now built and various other bits of gear so we can keep NV nice and light as a race boat should be when it comes time for us to set again. 

Ed Note: For the latest on Joanna, Timo and their infant son, Nemo, visit, or go to

July/August 2022



The Extraordinary Life and Mysterious Disappearance of Thomas Thor Tangvald

The first boat Thomas Tangvald ever owned was just 22 feet long. She was an odd craft, a narrow plywood scow with a flat bottom, leeboards on either side, and square ends—little more than a daysailer with a rotting deck and tiny cabinhouse tacked on. Thomas paid just $200 for more


USVI Charter Yacht Show Showcases a Flourishing Industry

As the U.S. Virgin Islands continues to attract sailors seeking to charter and explore the pristine territory on their own, the immense growth and expanded options for a crewed yacht or term charters have exploded here over the past five years. Last week, the USVI Charter more


Personal Locator Beacon Wins Top Design Award

The Ocean Signal RescueME PLB3 AIS Personal Locator took top honors at the 2022 DAME Design Awards, while Aceleron Essential, a cobalt-free lithium-iron phosphate battery with replaceable and upgradeable parts, won the first DAME Environmental Design Award. Announced each year more


EPIRB in the Golden Globe Race

Tapio Lehtinen’s boat sank early this morning southeast of South Africa while racing the Golden Globe Race, a faithfully low-tech reproduction of the 1968 Sunday Times Golden Globe. The boat went down quickly and stern-first according to the skipper’s emergency transmissions. more


Victory, Tragedy in the Route du Rhum

The 2022 Route du Rhum was a highly anticipated event in the ocean racing calendar, but few could have predicted exactly how challenging, dramatic, and tragic it would ultimately prove. French yachtsman Charles Caudrelier took home gold aboard the Ultim maxi trimaran Maxi Edmond more


Boat Review: Lyman-Morse LM46

Lyman-Morse has been building fine yachts in Thomaston, Maine, ever since Cabot Lyman first joined forces with Roger Morse back in 1978. With experience creating and modifying boats built of various materials, backed by its own in-house fabrication facility, the firm has more


Know-how: All-new Battery Tech

Until very recently, the batteries in sailboats used some form of lead-acid chemistry to store energy. Different manufacturers used different techniques and materials, but in the end, the chemistry and the process by which the batteries charge and discharge electricity remained more


At the Helm: When Things Go Sideways

I don’t like sea stories. My number one goal on every passage is to get the crew back in one piece. My number two goal is to get the boat back in one piece as well. If I can’t do both, I’ll take the former. Do this long enough, though, and things are going to happen, no matter more