Seamanship

The Fine Art of Gunkholing

by Kevin Walters, Posted March 10, 2011
July in Lake Huron’s North Channel is a special time. The cruising season is in full swing and what is normally a quiet wilderness area begins to come to life with cruisers looking for the perfect anchorage. Last year my family and I spent nearly a month in the North Channel visiting sleepy ports, rugged islands and one of the world’s largest freshwater fjords.The 1,000-mile round trip

Say Again

by Rod Glover, Posted January 18, 2011
There are many different ways to embarrass yourself while sailing. Having fenders hanging over your topsides or large scallops in your mainsail between the slides are two popular examples. Another is to use improper radio procedures. This demonstrates your incompetence not only to those who can see you, but to everyone within 20 miles.I am constantly frustrated by the poor procedures I

Passage Power

by Bruce Balan, Posted January 3, 2011
We are always told when outfitting our boats for cruising that we need to make sure our onboard electrical system can handle our projected daily power usage. But that raises an important question: what sort of day are we talking about? Is it a day spent at anchor, the day we have a lot of guests and friends on board, a day spent in a marina, or—and very often this is not considered—a day spent

Shaft Seal Cruising Tips - On Deck

by RON SCHAPER, Posted October 1, 2009
SHAFT SEAL SQUEALI was powering at low rpm when my wife asked, "What is that high-pitched sound?" I thought it was a belt, but when I went below and looked in the engine box all seemed fine. The noise seemed to be coming from behind the engine, so I lifted the small hatch over the PSS (Packless Sealing System) unit and found that the shaft, boot, and clamps were too

A Life Afloat

by Cindy Wallach, Posted September 3, 2009
Once upon a time there was a little girl who lived in the big city. One day the little girl’s mother and father brought her to a big garden center. There were rows and rows of seeds and bulbs and saplings, and in the very middle there was a sailboat. She climbed on board and found a little kitchen, a little bed, and even a little toilet. Her mother called to her, “Honey, what

Letting go a sheet

by Tom Cunliffe, Posted August 18, 2009
When the boat is tacking taking the loaded jibsheet off a winch can be a just cause for nervousness. On boats up to 40 feet or so, the safest way to do this is to first ease the sheet off a few inches; keep the flattened palm of one hand pressed against the turns on the drum as they begin to surge around it. This slight easing removes the worst of the load. Depending on the

Hitch consistency

by Charles Mason, Posted August 18, 2009
If you plan to be sailing in reduced light conditions make sure everyone uses the same procedure to secure a line around a cleat. If someone decides to use a fancy hitch during the day to secure a line it is easy enough to figure out how to free it up because it is right there in front of you. But when you are trying to clear an offbeat hitch in the dark, you might turn the
My wife, Des, and I have just finished a two-year circumnavigation of the Caribbean Basin. Among the things we learned was that some of the most important things that made our cruising more enjoyable cost less than ten bucks. Here are some of our favorites.
  1. Insulated tumblers Ice is a precious commodity at sea, and so is hot coffee. We used our insulated tumblers for hot coffee in

Dinghy Seamanship

by Fay Mark, Posted August 18, 2009
There’s an old saying that some of the most dangerous moments in sailing occur when people are in their dinghies. Over the years we’ve had lots of opportunities to see dinghies being handled well and poorly, and we’ve seen a lot more good and bad examples since we have been cruising in the Caribbean aboard our 54- foot cutter New Morning. We carry an 11-foot Zodiac

No-foul jib sheet

by Peter Nielsen, Posted August 5, 2009
The bowlines used to attach sheets to the clew of a headsail have an annoying habit of catching on inner forestays, babystays, and shrouds. Here’s a why-didn’t-I-think-of-this-before idea: if you’re replacing your headsail sheets, don’t cut them in half. Double the sheet over and thread the looped end through the clew. Pass the tails through the loop and draw tight. Then say goodbye to those
  • facebook
  • twitter