Boatworks Most Commented

Wired and Wonderful

by Don Casey, Posted July 14, 2009
Mike Montanaro of Cornelius, North Carolina, asks:

"Don Casey’s thorough and very informative article on the proper way to install shorepower on a boat (Sail, January) clarified a lot of points for me. But he says that if you touch both wires in a 12-volt DC circuit it is unlikely to cause injury. This assumes your body is the only current draw. What would happen if there


FULL STORY

Strength in Numbers

by Win Fowler, Posted July 14, 2009

John M. Bollinger of Bellevue, Ohio, asks:

 

"I’m planning to replace my halyards this summer and I would like to learn how to splice them to the shackles myself. Where can I find this information?"

Win Fowler replies:

Splicing techniques vary depending on the type of cordage you plan to use. Most manufacturers provide detailed splicing


FULL STORY

Fix-it kit

by Sail Staff, Posted June 22, 2009
Nothing will ruin your cruise faster than a damaged or torn sail. With the BoatWorks sail-repair kit on board, you’ll be able to make emergency repairs and keep on sailing. Ours cost less than $100 to assemble but could save us hundreds in repair bills.

A. Curved and straight needles of different diameters.

B. Stainless-steel scissors for cutting thread and sailcloth.

C.


FULL STORY

Keel improvements

by Peter Nielsen, Posted June 22, 2009
Jabberwock, the BoatWorks project O’Day 25, was looking very scruffy around the underparts. The boat had been standing for so long that most of the paint had just fallen off the bottom, and the keel was looking particularly seedy. There was no way we could launch the boat with the keel in such bad condition. It was time for a makeover. A proper keel job done by a boatyard will cost
FULL STORY

Battery Buildup

by Nigel Calder, Posted June 20, 2009
Joseph Strong of Barrington, Rhode Island, asks:

"I am repowering my Bristol 35.5 with a Yanmar model 3YM30 diesel engine, but I also want to increase my electrical capacity. Currently I have two 12-volt batteries with a standard three-way battery switch (Bat. 1, Bat. 2, and Both). I would like to add two more 12-volt batteries and align them like the two-bank configuration


FULL STORY
  • facebook
  • twitter